Same-Day Plumbing Repair & Replacement in Wilmore, KY

Removed and replaced defective ejector pump system accessed through wall-mounted access panel. Addressed water damage to bathroom flooring caused by pump failure, with visible staining and deterioration to subfloor material. Installed new ejector pump assembly with PVC discharge piping and verified proper drainage function through P-trap configuration. All plumbing connections secured and tested for leaks prior to closing access panel.

Responded to backup issues affecting toilet and tub, with suspected main drain obstruction. Upon arrival, determined floor had been removed for access and completed main drain cleanout. Extracted significant accumulation of fibrous material, lint, and debris causing the blockage. The clog material removed showed heavy buildup consistent with washing machine discharge contributing to the main line obstruction. Cleared drain line and restored proper flow to all affected fixtures.

Completed comprehensive care plan tune-up on two geothermal systems located in basement, with third water-to-water geothermal unit servicing floor heating system monitored for water pressure only. Verified system pressures using calibrated gauges, recorded supply air temperature readings of 64.3°F at ductwork, and installed customer-supplied 14x20x1 air filter. All systems operating within normal parameters with no issues identified during maintenance inspection.

Completed comprehensive AC tune-up on attic-located air conditioning system installed in 2020. Performed full system inspection including blower assembly examination, verified electrical components with clamp meter at outdoor condenser unit, and confirmed all operational parameters within manufacturer specifications. Customer to provide filters for future maintenance.

Completed Gold Level prepaid maintenance on single-system heat pump with air handler located in crawlspace. Replaced customer-supplied Aprilaire #413 filter and performed standard maintenance protocol. Addressed customer concern regarding equipment vibration issues related to previous elevation work; discussed alternative mounting solutions using cinder block supports to prevent humidifier flooding while eliminating floor joist vibration transfer into living space.

Completed preventive maintenance on Club Duo geothermal split system. Accessed attic-mounted air handler, performed electrical diagnostics on control board using digital multimeter with readings at 10.5 volts, and verified proper operation of all system components. All equipment tested and confirmed operational within manufacturer specifications.

Responded to plumbing preventive service appointment for tanked water heater maintenance. Upon arrival, conducted visual inspection of water heater and associated plumbing components. Observed significant mineral buildup and crystalline deposits on drain valve assembly, indicating hard water conditions and extended service interval. The white chalky accumulation was present on the valve body and surrounding connections, consistent with calcium and magnesium precipitation. Per service agreement specifications, no flush procedure was performed during this visit as indicated in the recurring maintenance schedule. Documented existing conditions through photographic evidence, capturing the mineral deposits on the drain valve mechanism and deteriorated sealant material at pipe connections. The flexible hose connection showed signs of aging with compromised sealing compound exhibiting flaking and crumbling texture around the junction points. All observations recorded for maintenance history

Completed comprehensive plumbing inspection of water heater system and associated components. Inspected water heater installation, expansion tank mounting, copper piping, PEX supply lines (hot and cold), brass shut-off valves, and flexible supply connections. All components were found to be properly installed with secure mounting brackets, professional-grade fittings, and appropriate pipe routing. System appears to be functioning as designed with no visible leaks or deficiencies noted at time of inspection.

Completed preventative maintenance tune-up on ground floor air conditioning system as part of club membership care plan. Inspected system components, cleaned condenser coils, checked refrigerant levels, tested electrical connections, and verified proper operation of all equipment. Removed debris and old components from unit, documented equipment specifications, and confirmed system is operating within manufacturer parameters for optimal cooling efficiency.

Installed a Bradford White 50-gallon electric short water heater (24" x 47 3/16") in crawl space with 6-year tank and parts warranty and 1-year labor warranty. Removed and disposed of existing water heater, reconnected all copper supply piping and fittings to existing water lines, restored electrical connections to existing circuit, and secured unit on gravel foundation between floor joists. Obtained required plumbing permit and arranged for inspection to ensure code compliance.

Responded to no cooling call on 3-year-old electric AC system with blank thermostat and no airflow. Upon inspection, discovered complete loss of power to indoor air handler due to failed control board, evidenced by no response from thermostat or system components. Found significant moisture accumulation and mineral buildup on internal components of air handler, indicating previous condensate drain issues that likely contributed to electrical component failure. Replaced faulty control board, verified proper voltage and amp draw, tested all safety controls, and restored full system operation with proper airflow and cooling capacity.

Returned to property to address crawl space flooding issues and equipment relocation. Replaced shorted condensate pump that had failed due to water exposure and mounted new unit on cinder block support column to elevate above ground level. Relocated AprilAire dehumidifier from garage back to crawl space and secured unit to floor joists using metal straps per customer preference, eliminating ground contact and reducing future flood risk. Verified proper drainage connections and electrical operation of both units before completing installation.

Completed annual preventative maintenance on a two-year-old residential air conditioning system as part of club membership benefits. Performed comprehensive AC tune-up including inspection of the single air handler unit with 1 HP blower motor. Accessed washable filter from crawlspace and verified proper airflow. Measured compressor amperage draw at 8.2 amps using clamp meter, confirming unit is operating within manufacturer specifications. Inspected blower wheel assembly and verified all blades are clean and free of debris with proper motor mounting. Checked all electrical connections at the outdoor unit and documented system performance. Unit showed no issues and is operating efficiently with no repairs needed at this time.

Conducted on-site assessment of leaking water heater in basement crawl space. Inspected existing Whirlpool residential water heater unit, documented copper supply line connections, PVC discharge piping configuration, and identified source of leak requiring replacement. Evaluated customer's request for hose spigot relocation work and provided comprehensive estimate for water heater replacement and plumbing modifications.

Returned to property to complete wiring installation between furnace and outdoor unit. Ran shielded gray wire from indoor furnace location through crawlspace to ODU as specified, ensuring proper connection and signal communication between components. Verified system operation and documented existing crawlspace conditions including water heater installation and overhead moisture damage for customer awareness.

Conducted electrical site assessment for Kohler generator installation. Documented existing 42-circuit main electrical panel configuration, photographed circuit directory with labeled branch circuits serving living areas, HVAC systems, kitchen appliances, and air conditioning equipment. Evaluated panel capacity and available circuits to determine integration requirements for automatic transfer switch and generator connection.

Completed Gold Level preventive maintenance on single-zone heat pump and air handler system. Inspected air handler interior and ductwork, confirming insulation integrity and proper system cleanliness. Performed electrical diagnostics using clamp meter to verify capacitor readings and system performance, with measurements indicating 5.8 MFD. Customer provided filters for replacement, and UV bulb condition was assessed per maintenance protocol.

Completed comprehensive Gold Level preventive maintenance service on dual HVAC system. Performed electrical diagnostics using clamp meter to verify proper amperage draw and system operation on both units. Measured and recorded refrigerant pressures to ensure optimal system performance and proper charge levels. Inspected all electrical connections, control boards, and wiring for signs of wear or potential issues. Both systems operating within manufacturer specifications with no deficiencies noted at time of service.

Responded to no cooling call on 3-year-old geothermal system. Upon arrival, discovered that the 240-volt power supply line to the outdoor unit had been severed. Repaired the damaged electrical line, restored power to the unit, and verified proper system operation with cooling restored.

Completed warranty return to re-route condensate drainage system for freeze prevention. Installed 3/4" PVC piping through exterior wall with tee fitting and standpipe vent at top to allow proper drainage and prevent freeze-ups. Added 3/8" vinyl tubing with loop configuration before PVC connection as additional freeze protection measure. Removed existing condo tubing from drain line and sealed opening with silicone as temporary solution pending plumbing contractor's permanent repair work.