Top-Rated Heating, Cooling in Lexington, KY

Conducted site assessment of existing Bradford White water heater in basement location. Unit shows aging copper supply lines and requires replacement. Documented current installation configuration and drain pan placement for accurate estimate preparation.

Performed scheduled Care Plan tune-up on dual Goodman HVAC system (2 furnaces/2 AC units) with one furnace located in attic. Inspected Daikin unit's electrical connections, finding all wire nuts secure and properly connected to control board. Examined igniter rod and heat exchanger components, noting normal wear with minor dust accumulation but no significant corrosion requiring immediate attention.

Completed routine Care Plan Tune Up on heat pump/air handler system located in basement. Performed amp draw measurement with Fieldpiece SC440 clamp meter (reading 7.10 amps) and inspected dual run capacitor (40/5 MFD 370V). Customer provided 20x24x1 air filter which was replaced during service.

Conducted a PSA plumbing inspection, examining sink drain assembly components and P-trap connections. Identified minor water staining around wall penetrations. Also inspected basement/crawl space area where evidence of moisture intrusion was observed at the foundation wall-floor junction, with visible efflorescence and water staining on cinder block walls.

Responded to service call for non-functioning bedroom outlets. Performed diagnostic inspection revealing faulty wiring connections in the electrical junction box. Accessed ceiling and wall electrical boxes, rewired connections properly, and verified functionality of previously non-operational outlets. All work completed to code specifications.

Performed scheduled Care Plan Tune Up on Carrier system. Inspected and tested the furnace unit located in attic, confirmed proper installation of insulated ductwork and ventilation. Checked thermostat operation, verified display functionality and temperature reading accuracy. System functioning normally with no issues detected.

Performed routine plumbing inspection of facility's utility area, examining all visible piping systems including PVC, black insulated pipes, and connection points. Tested shower fixture functionality, confirming proper water flow and pressure through the stainless steel handheld shower head. All plumbing systems were found to be in normal working condition with no visible leaks or deterioration.

Performed comprehensive HVAC tune-up service including electrical system inspection. Conducted amperage measurements on electrical components using Fieldpiece SC440 clamp meter, recording readings of 203.0A and 195.8A on various circuits. Inspected wiring connections, noting some wear on insulation that may require future attention.

Responded to service call for sump pump repair. Found broken discharge pipe requiring reattachment. Installed new PVC pipe with Legend model 0703 coupling (1¼" - 1½") secured with metal hose clamps to reconnect the discharge line from sump pump to outside drainage, successfully resolving basement water leakage issue.

Performed scheduled Care Plan Tune-Up on dual AC and furnace systems located in attic and crawl space. Conducted electrical testing with clamp meter (72.9A reading) and inspected blower motor components. Customer advised they need replacement filters (16x25x4, 20x25x4), which will be provided at next appointment scheduled after 1:00.

Completed Club Duo maintenance on dual AC and gas furnace systems as part of customer's care plan. Observed significant rust and corrosion on the furnace ductwork/plenum connection, documented with photos for future reference. Customer provided their own filters for the service.

Responded to a service call for shower pressure issues in the master bathroom. Upon inspection, found the handheld shower unit was functioning with suboptimal pressure despite normal water flow to other fixtures in the home. Diagnosed and cleared mineral buildup in the shower head and pressure regulator, restoring proper water flow and pressure to the affected fixture.

Successfully replaced customer's outdoor AC unit under warranty. Installed new Daikin equipment in the existing location between brick wall and building exterior, ensuring proper positioning and connection of all refrigerant lines and electrical components. Unit is now operational and warranty service is complete.

Completed electrical assessment for customer's multiple code compliance projects required by KU. Performed inspection of main electrical distribution panel which showed aging wiring, cluttered wire bundles, and mixed breaker types. Panel exhibited signs of wear with various wire gauges and inconsistent organization that would need to be addressed to meet current electrical standards.

Conducted routine plumbing inspection of toilet fixture as requested through PSA. Examined interior tank components showing normal mineral buildup and wear, and verified integrity of the stainless steel braided water supply line and wall connection. No immediate issues requiring repair were identified.

Performed scheduled Care Plan Tune Up on two AC units and two gas furnaces located in attic and basement. Conducted electrical testing with multimeter on components, obtaining satisfactory readings. Inspected exterior foundation access panel and evaluated surrounding drainage provisions. Customer-supplied filters were installed as part of maintenance protocol.

Conducted routine plumbing inspection as part of preventive service agreement. Examined water heater system, checking all connections, exhaust venting, and supply pipes for proper installation and potential leaks. Also inspected bathroom shower fixture, including handheld showerhead, sliding rail system, control valve, and flexible hose connection - all components found to be in good working condition with no visible issues.

Completed scheduled Care Plan Tune Up on ground floor AC system. Performed comprehensive inspection of electrical components and wiring, ensuring all connections were secure and properly functioning. Verified thermostat operation with current room temperature reading at 72°F. System is operating within normal parameters.

Responded to water leak service call where customer reported steady drip from unit in basement that began previous week. Upon inspection of the HVAC system, identified water leakage at PVC condensate drain line connection point. Repaired damaged elbow joint in the condensate drainage system and verified proper drainage operation with no further leakage observed.

Performed Care Plan Tune Up on dual heat pump and air handler systems. Inspected and tested electrical components, including capacitor and voltage readings (196.7V AC). Units located in attic and upstairs laundry room were thoroughly evaluated for proper operation.