Top-Rated Heating, Cooling in Lexington, KY

Responded to a non-urgent demand service call regarding high electric bills. Conducted thorough inspection of HVAC system with particular focus on ductwork in the crawl space. Observed significant issues with duct insulation integrity and sealing, documenting multiple areas where reflective insulation was compromised and connections needed re-sealing to prevent energy loss.

I performed a comprehensive flush service on a wall-mounted tankless water heater that had never been previously maintained. Upon inspection, the unit was experiencing decreased hot water duration due to mineral buildup. Successfully completed descaling procedure, cleaned inlet filter, and verified proper gas line connection. System now operating at optimal efficiency with restored hot water performance.

Performed comprehensive maintenance on three HVAC systems (12 years old) located in attic, basement, and apartment above garage. Inspected electrical connections, ductwork integrity, and system components in all three units, noting well-maintained reflective insulation on attic ductwork. Replaced 14x20x1 disposable filter as part of routine service; advised client regarding future GreenPac filter requirements.

Performed scheduled maintenance service on four heat pump systems as part of planned service agreement. Conducted electrical current measurements on multiple circuits using clamp meter, with readings of 0.79A and 20.57A recorded during diagnostics. Systems were located in closets and attic spaces, requiring ladder access for complete inspection and service.

Completed scheduled preventative maintenance on air conditioning system. Inspected and documented internal electrical components, including circuit board, wire connections, and control panel. All components found to be in working order with no visible issues detected.

Performed scheduled Care Plan Tune Up on multiple HVAC systems (heat pump/air handler x2 and heat pump/gas furnace) located in main residence and guest quarters. Inspected electrical components including capacitor (35μF 250VAC CBB65P) and junction box connections, and examined insulation integrity around PVC piping and electrical pathways.

Performed annual Care Plan Tune Up on heat pump/air handler system located in attic. Conducted electrical testing using Fluke 323 clamp meter, measuring amperage draw (2.00A) and voltage (190V) at control board. Inspected internal components and wiring connections to ensure proper operation of system.

Repaired small leak in master bathroom shower wand and performed comprehensive assessment of plumbing system for potential installation of water leak/freeze detection shut-off valve. Inspected existing water heater installation and main plumbing infrastructure to determine compatibility and requirements for automated shut-off system.

Performed annual Care Plan Tune Up on heat pump/air handler system located in attic. Conducted amperage testing of electrical components with readings at 0.63A, confirming proper operation. Inspected condenser unit and verified all connections. Customer will supply replacement filters as needed.

Responded to water leak service call and identified that the condensate drain pipe from the furnace was approximately 0.5-1.5 inches too short, causing steady water leakage into the utility room and garage area. Documented moisture damage to concrete floor and surrounding materials with visible staining and deterioration. Extended drain pipe to proper length to eliminate the ongoing leak issue.

Responded to water leak service call for indoor HVAC unit located in attic. Upon inspection, identified condensate drain pan overflow causing ceiling water stains. Cleared blocked drain line and verified proper drainage function to prevent future leakage.

Performed scheduled maintenance on residential AC system located in basement. Conducted electrical diagnostic testing using clamp meter, measuring amperage at 44.74A. Inspected capacitor connections and found moderate dust accumulation and cobwebs; verified all colored wiring terminals were secure with no signs of overheating or damage.

Successfully installed a complete Friedrich Breeze HVAC system, including a 2-ton Side Discharge 18 SEER2 heat pump, matching air handler with 10KW auxiliary heat kit, and Honeywell TH6320U2008/U thermostat. System installation included all necessary components: outdoor unit pad, snow legs, electrical connections, refrigerant line insulation/filter, drain trap, SS2 coil drain safety water sensor, and transition to existing ductwork.

Performed biannual Care Plan maintenance on dual heat pump and air handler system located in attic and basement. Conducted comprehensive electrical diagnostics using clamp meter, measuring amperage draw (156A) and voltage (-18.43V) at the control panel. All components functioning within specifications; customer provides their own filters.

Responded to service call regarding a beeping smoke detector. Upon inspection, removed and examined two ceiling-mounted smoke detectors, checking terminal connections and internal components. Successfully diagnosed the issue, reattached the devices to their ceiling mounts, and verified proper operation with no further alarm activation.

Excavated approximately 2-3 feet to expose sewer line and installed new cleanout at exterior foundation wall. Capped existing sewer line in crawlspace where female threads were intact. Job included hazardous materials handling due to standing sewage in crawlspace.

Successfully installed new 50-gallon Bradford White gas water heater in garage as scheduled. Completed all necessary connections including copper/PEX supply lines, gas line with proper fittings, and ventilation system. System tested and functioning properly with no leaks detected.

Completed electrical estimate for converting gas range to electric installation. Assessed existing electrical infrastructure, including cabinet-housed outlets and access panels, to determine requirements for proper 240V dedicated circuit installation and ventilation needs.

Inspected existing 87-gallon water heater system for potential replacement. Disconnected water line from refrigerator as customer is transitioning to a non-ice maker model. Coordinated with on-site electrician regarding customer's conversion from gas to induction cooking appliance.

Performed scheduled Care Plan Tune Up on ground floor air conditioning system in crawlspace. Inspected and tested capacitor (CSC 10, 43-101665-10) with Fieldpiece meter. Customer provided filters for service.