Top-Rated Heating, Cooling in Lexington, KY

Responded to callback for water leak originating from HVAC piping in attic space following recent service work. Upon arrival, documented extensive water damage and staining on bedroom ceiling with discoloration following ceiling panel seams. Accessed attic space and inspected PVC condensate drain lines running through insulated area above affected room. Located active leak at pipe connection point near previous repair site. Identified improper fitting installation as source of water intrusion causing ceiling damage below. Repaired faulty connection, secured all pipe sections, and verified proper drainage operation. Confirmed no additional leaks present and system operating correctly.

# HVAC Service Call - Geothermal System No Airflow Responded to no cooling complaint on 11-year-old geothermal heat pump system. Customer reported unit humming but no air coming from vents. Upon arrival, confirmed geothermal unit was running but air handler blower was not operating. **Diagnostic Findings:** Inspected air handler and evaporator coil assembly in basement mechanical room. Observed significant corrosion on metal housing panels along evaporator coil cabinet edges. Checked electrical connections at blower motor and verified power supply to unit. Tested blower motor capacitor and found failed capacitor preventing blower motor from starting. Motor was attempting to run (humming sound) but could not overcome starting torque without functional capacitor. Examined overall system condition during inspection. Noted age-related deterioration including rust on cabinet panels and moisture staining on base pan beneath evaporator coil. Refrigerant lines and insulation appeared intac

Responded to error code call and performed Gold Level prepaid maintenance tune-up on two heat pump systems in residential property. Upon arrival, system had been reset by customer and was operational. Completed comprehensive diagnostic testing on both units - one located in basement, one on second finished floor. Inspection revealed significant frost accumulation on evaporator coil, indicating potential refrigerant flow or airflow restriction issues. Measured electrical amperage at 18.8A and monitored system temperatures reading 53.3°F. Tested all electrical components including circuit breakers, capacitors, and wiring connections. Performed standard maintenance protocol including system performance verification, electrical testing with clamp meter, and visual inspection of all accessible components. Both systems operating at time of service completion. Customer provides own filters for units.

Responded to callback for HVAC system not switching to cooling mode with indoor temperature at 80°F. Upon inspection, verified condensate drainage system operation and measured ambient temperatures in mechanical area to diagnose cooling failure. System evaluated and corrective measures taken to restore proper cooling functionality.

Conducted plumbing estimate for replacement of galvanized piping with PVC in crawlspace and exterior backyard area. Assessed existing piping infrastructure showing signs of corrosion and deterioration, documented conditions for comprehensive pipe replacement scope including interior mechanical spaces and outdoor foundation perimeter sections.

Responded to a main drain blockage causing toilet backup into shower. Accessed main drain cleanout in basement utility area and cleared obstruction in the primary waste line. Verified proper drainage flow through the system, restoring normal function to affected fixtures.

Responded to no cooling call on electric HVAC system over 10 years old. Thermostat displayed cooling mode but system was not running, with indoor temperature at 74 degrees against setpoint of 71 degrees. Accessed indoor unit located in crawlspace and documented equipment model number BCS3M30C00NA1P-1 for diagnostic purposes.

Completed Care Plan tune-up service on multi-unit system with two air conditioning units and two gas furnaces located in attic and basement. Performed comprehensive maintenance including system inspections, operational testing, and safety checks on all equipment. Documented humidifier component showing significant mineral buildup and discoloration on water panel evaporator pad with honeycomb mesh pattern, indicating need for future replacement due to hard water deposits and potential biological growth. Customer-supplied Honeywell 20x25x4 filter not included in service. Coordinated arrival time as requested prior to service visit.

Completed rough-in plumbing work for bathroom renovation project. Installed white PVC drainage and supply lines through exposed floor joists and wall framing, including proper vertical pipe routing and water filtration system integration. Work included coordination with electrical infrastructure, ensuring all plumbing rough-in meets code requirements for future fixture set-out and finish work.

Completed full residential HVAC system installation including Ruud RP14AY30AJ2NA heat pump outdoor unit, RH2TY3617STANNJ air handler, and RXBH-1724A10J-B electric heat kit. Installed outdoor unit on new concrete pad with snow legs, electrical disconnect box, and electrical whip kit. Applied refrigerant line insulation and installed refrigerant line filter. Ran new high voltage wiring to air handler for electric heat strips. Installed air handler in utility closet with trap, SS2 coil drain safety water sensor, ceiling saver overflow drain pan with water sensor, and standard air filter rack. Fabricated transitions to connect to existing ductwork. Replaced condenser fan motor and installed new Honeywell S200 thermostat. Removed and disposed of existing equipment. Obtained applicable permits and ensured code compliance. System tested and verified operational with proper airflow, refrigerant charge, and electrical connections. Provided customer with warranty documentation covering one year

Completed comprehensive Care Plan maintenance on dual heat pump system with gas furnace and air handlers located in attic and basement. Performed full system tune-up on both heat pump units, inspecting electrical connections, refrigerant levels, and operational performance. Measured airflow readings showing 492 CFM at attic air handler unit. Inspected ductwork throughout attic space, noting flexible duct routing and connections to air handler. Customer requested UV light installation during maintenance visit; discussed installation options and placement for optimal air purification effectiveness within the air handler system.

# HVAC Service Completed Responded to no cooling complaint on 2-year-old Bryant air conditioning system covered under Greenbox warranty. Upon arrival, located air handler unit installed in utility closet with visible ductwork connections and condensate drainage system in place. Performed diagnostic evaluation of system operation and airflow. Measured supply air temperature at air handler, recording 53.3°F at the supply plenum using calibrated digital thermometer. Inspected air handler cabinet, ductwork connections including silver flex ducting at supply, and black refrigerant line insulation. Verified condensate drain line configuration with white PVC piping and proper drainage routing. Evaluated system components including blower operation, evaporator coil condition, and refrigerant line temperatures. Documented equipment nameplate data and warranty information from manufacturer labels on air handler cabinet. Assessed insulation integrity on refrigerant lines and ductwork, noting R

Responded to no cooling complaint on upstairs air conditioning system. Upon arrival, performed diagnostic testing using digital meters to check electrical parameters and refrigerant temperatures. Measurements indicated system operating at 600 volts with 0.5 amp draw, and superheat reading of 58.5°F at the outdoor unit, suggesting potential refrigerant charge issue or restriction in the system. Further evaluation needed to determine root cause of cooling failure.

Performed comprehensive maintenance inspection on 10-year-old geothermal system with indoor unit located in walk-out basement for new homeowner. Conducted electrical diagnostics using multimeter to verify system operation, checked refrigerant pressures on geothermal loop system, and performed general cleaning and inspection of equipment. All system parameters found to be within normal operating range.

Completed comprehensive Care Plan tune-up on heat pump system with air handler located in attic accessible through garage. Performed electrical diagnostics on outdoor condensing unit using clamp meter to verify amperage draws and system performance, measuring compressor and fan motor current. Conducted refrigerant charge verification using digital scale to ensure proper system capacity. All components operating within manufacturer specifications at time of inspection.

Replaced defective branch box that supplies refrigerant to all three indoor head units on multi-zone LG ductless split system. Performed temperature diagnostics on affected heads, confirming proper airflow and refrigerant distribution post-repair, with discharge temperatures reading within manufacturer specifications.

Completed comprehensive cooling maintenance on a 5-year-old Carrier air conditioning system that was operating properly. Performed full AC tune-up including electrical diagnostics with clamp meter showing 0.9 amp draw, temperature measurements at refrigerant lines reading 40.0°F at suction line, and thorough inspection of outdoor condenser unit. System check confirmed proper operation with all components functioning within normal parameters.

Completed comprehensive one-time tune-up service on three HVAC systems in preparation for property sale, including one attic-mounted unit and two crawlspace installations. Performed standard maintenance procedures including air filter replacement across all systems and full operational inspections. Addressed condensate management issues by repairing loose drain line connection at external condensate trap where water was pooling beneath furnace, then extended all condensate discharge lines away from foundation to prevent future moisture damage. Installed protective wire screening over exterior intake and exhaust PVC terminations to prevent wildlife and bird intrusion into combustion air and flue gas piping. All systems tested and confirmed operational following service completion.

Completed comprehensive Care Plan tune-up on dual-system HVAC configuration with heat pumps and air handlers located in attic and basement. Performed full diagnostic testing on outdoor units including capacitor voltage verification reading 393.6V and temperature differential measurements of 32.9°F, confirming proper system operation and component functionality across both zones.

Completed Care Plan maintenance on dual air conditioning systems and dual gas furnace units located in attic and crawl space. Performed comprehensive inspection and routine maintenance procedures on both outdoor condenser units. Observed significant accumulation of dried leaves and organic debris surrounding both condensers, which was cleared to ensure proper airflow and system efficiency. Inspected refrigerant lines, electrical connections, and condensate drainage systems. All equipment operational at time of service completion.