Top-Rated Plumbing in Lexington, KY

Replaced outdoor condensing unit under manufacturer's 1-year warranty with new Lennox equipment. Installed surge protector for electrical protection and documented new unit's nameplate information with photographs for warranty claim processing.

Responded to no-cooling complaint on 17-year-old Carrier electric HVAC system located in utility room. Upon arrival, unit was off due to evaporator coil freeze-up occurring over previous several days. Performed diagnostic evaluation and confirmed suspected refrigerant leak. Documented system condition including deteriorated wooden structural support elements near installation area showing significant moisture damage and wood rot. Recommended system replacement due to age, refrigerant leak, and compromised installation integrity.

Responded to a slab leak in copper water line previously identified by leak detection services. Cut and removed interior flooring at marked location and used concrete saw and jackhammer to access the affected plumbing line beneath the slab. Located the leaking copper pipe, performed necessary repairs to restore water line integrity, and wrapped the repaired section for protection. Poured concrete to restore the slab foundation and verified proper system function with no additional leaks detected before completing the work.

Responded to clogged drain line affecting dishwasher operation. Upon inspection of the under-sink plumbing assembly, identified blockage in the drainage system connected to the dishwasher discharge line. Cleared obstruction from the drain line using appropriate methods, ensuring proper water flow through the P-trap assembly and main drainage piping. Verified all connections, including the black rubber dishwasher discharge hose secured with metal hose clamps to the white PVC drainage system, were properly seated and functioning. Tested system operation to confirm complete drainage and no leaks present at any connection points.

Responded to service call for air conditioning system not adequately cooling unoccupied residence. Upon arrival, verified thermostat set to 71°F in cooling mode and inspected HVAC equipment. Examined air handler unit and confirmed GeneralAire 16x25x5 MERV-rated filter was installed in system. System evaluated for cooling performance concerns reported by property caretaker.

Conducted comprehensive electrical assessment for generator installation at residential property. Evaluated existing electrical panel condition, noting deteriorated interior door panel requiring attention prior to generator integration. Documented current circuit breaker configuration and available capacity in main service panel to determine proper sizing and connection requirements for standby generator system. Assessed utility room electrical infrastructure and load requirements to ensure adequate power distribution for proposed automatic transfer switch installation.

Completed routine plumbing inspection as part of preventative service agreement. Verified proper water flow and drainage at bathroom sink fixture, tested faucet operation and water supply controls, and inspected accessible plumbing infrastructure in attic space for any visible leaks, proper insulation clearances, or maintenance concerns. All plumbing systems found operating within normal parameters with no immediate issues identified.

Completed comprehensive plumbing inspection as part of routine preventive service agreement maintenance. Performed thorough examination of toilet tank components, including flush valve assembly, flapper mechanism, fill valve, and float assembly; noted mineral deposits and sediment buildup consistent with normal usage, with all components functioning properly at time of inspection.

Completed annual care plan maintenance on air conditioning and gas furnace system located in basement. Performed comprehensive tune-up including electrical diagnostics using clamp meter to verify proper amperage draw and system performance, inspected dual capacitor assembly and associated wiring connections, and installed customer-provided 20x25x1 air filters. All components tested within normal operating parameters.

Performed Care Plan tune-up on heat pump air handler system and mini-split unit located in crawlspace and second floor. Conducted electrical diagnostics and measurements using clamp meter, verified voltage readings at 450V and amperage at 702mA on system components, and completed preventive maintenance inspection per club membership agreement.

Completed routine air conditioning tune-up on an eight-year-old cooling system with air handler located in attic. Performed comprehensive maintenance inspection including electrical testing of blower motor components, which measured 1.93 amps, and verified proper operation of condensate drain system with clear inspection port. All system components inspected and found operating within normal parameters.

Completed routine plumbing inspection of bathroom fixtures as part of preventative service agreement. Performed operational testing of faucet, verified proper water flow and drainage at vanity sink, and inspected shut-off valves beneath the fixture to ensure proper function and absence of leaks.

Completed full residential HVAC system installation including Bryant 60K BTU 96% efficiency gas furnace (model 916SA36060M14), Bryant 2-ton 16 SEER2 air conditioning condenser unit (model GA5SAN52400W), and Bryant 2-ton evaporator coil (model CVAVA2414XMA). Installed digital thermostat, condensate pump, and REME Halo UV air purification system for enhanced indoor air quality. Applied new ArmaFlex insulation to outdoor suction lines, drilled and installed 2" PVC concentric vent kit through exterior wall for furnace exhaust and intake, and positioned condenser unit on concrete pad with proper electrical connections and refrigerant line routing. Removed and disposed of existing equipment, pulled necessary permits, and tested all system components for proper operation and code compliance.

Responded to service call for sump pump testing and water shutoff valve evaluation in 87-year-old residential basement following home inspection findings. Conducted comprehensive assessment of sump pump functionality and operational capacity in deteriorated basement environment showing extensive water damage, mold growth, and structural decay. Inspected water shutoff valve in separate basement area for active leaking and determined replacement requirements. Both plumbing components exhibited age-related deterioration consistent with the home's construction era, with significant accumulation of sediment, debris, and moisture damage evident throughout the work areas. Documented existing conditions through photographic evidence showing compromised surfaces, corroded piping, and environmental degradation requiring immediate attention to prevent further water intrusion and potential flooding risks.

Performed comprehensive HVAC system replacement at residential property. Removed existing air conditioning unit and installed new cylindrical condenser unit on concrete pad adjacent to house exterior. Connected refrigerant lines with proper fittings, installed electrical disconnect box on exterior wall, and ran necessary conduit for power supply. Charged system with refrigerant, verified proper pressures using manifold gauges, and tested all electrical connections. System operational and running within manufacturer specifications upon completion.

Responded to no cooling complaint on residential air conditioning system. Upon inspection, found evaporator coil completely frozen with heavy ice buildup and indoor coil fins severely clogged with dust and debris accumulation. Identified restricted airflow as primary cause due to lack of maintenance and dirty coil conditions. Shut down system to allow ice to thaw completely. Performed thorough coil cleaning to remove accumulated dirt and debris from evaporator fins. Verified proper refrigerant levels and system pressures after thaw cycle completed. Checked blower motor operation and airflow. System restored to normal cooling operation with improved airflow and heat transfer efficiency. Recommended regular filter changes and preventive maintenance to prevent future freeze-ups.

Temporarily removed previously installed stainless steel double-basin kitchen sink with chrome faucet and spray attachment to allow countertop contractor access for their installation work. Sink and fixtures were carefully disconnected and staged in protected area. Upon completion of countertop work, reinstalled kitchen sink, reconnected all plumbing lines, and verified proper drainage and water supply functionality before departure.

Responded to no cooling complaint on 5-year-old electric air conditioning system. Upon arrival, thermostat displayed 83°F actual temperature while set to 72°F in cooling mode with fan circulating. Performed diagnostic evaluation of indoor air handler and outdoor condensing unit located in multi-unit installation. Identified system malfunction, completed necessary repairs to restore proper cooling operation, and verified system functionality before departure.

Completed comprehensive AC tune-up on Carrier air conditioning and gas furnace system located in garage utility closet. Performed routine maintenance inspection including checking refrigerant levels, cleaning condenser coils, inspecting electrical connections, testing thermostat operation, verifying proper condensate drain function through PVC drainage system, and examining flex ductwork connections for secure sealing. System operational and running efficiently with no issues identified during service visit.

Responded to no cooling complaint on wall-mounted mini-split system in commercial kitchen. Upon inspection, found evaporator coil heavily contaminated with dust, dirt, and debris accumulation restricting airflow and reducing heat transfer efficiency. Removed front cover and accessed internal components. Cleaned evaporator coil assembly thoroughly, removing built-up contamination from fins and backing plates. Verified unit now cooling properly with adequate airflow through vents. Recommended more frequent filter maintenance to prevent future coil fouling.